I am aware. But to keep COP of 6 this either means over time, due to the reduced amount of nickel ( it is slowly 'consumed') the temperature of the remaining nickel has to be increased, or, the available nickel is only a part of the nickel is active at the time. If the temperature of the reduced amound of nickel has to be increased, this means more input power is required for the same amount of output heat and therefore COP get less over time.
Op maandag 10 juni 2013 schreef Axil Axil ([email protected]) het volgende: > Rossi must keep the COP at or below 6 to avoid reaction meltdown. The LENR > reaction must be controlled to avoid the disruption consequences of > infinite COP. > > > > > On Mon, Jun 10, 2013 at 6:43 AM, Teslaalset > <[email protected]<javascript:_e({}, 'cvml', > '[email protected]');> > > wrote: > >> I wonder wether all present powder will be active at once. It seems only >> part of the the powder is in an active state. >> If all powder is in an active state all the time, COP will decrease over >> time as the material is 'consumed'. This would mean, in the case of an >> e-cat, COP is only 6 in the initial time period of the indicated 6 months. >> >> Op zondag 9 juni 2013 schreef Axil Axil >> ([email protected]<javascript:_e({}, 'cvml', '[email protected]');>) >> het volgende: >> >> The heat transfer contact is very good because it is made by quantum >>> effects caused by the BEC. I believe that the powder is super-fluidic. That >>> means that the hydrogen gas and the powder and maybe even the containment >>> tube are the same temperature (exothermic). >>> >>> >>> On Sun, Jun 9, 2013 at 3:16 PM, Teslaalset >>> <[email protected]>wrote: >>> >>>> Major problem is that it is hot powder than needs to transfer its heat. >>>> It simply has a bad contact with the heat exchanger. >>>> >>>> >>>> >>>> >>> >
