Yes the magneto-caloric effect.

 

This precisely what we think is happening (rather could be happening if there 
was actual gain) where the moving magnetic field creates EMF in the windings 
and cooling in the core BUT where the cooling loss balances the EM gain. Best 
of both.

 

BTW – the windings around the billet are on x,y and z axes and the effect 
happens at what turns out to be the Larmor frequency of the ferrite. We did not 
know that initially.

 

I should add – for the benefit of others who may wonder why this project was 
stopped… that Arthur Manelas suffered a severe stroke and is still bedridden 
but alive. It is one of those stories that I hate to repeat, since it sounds 
too much like the typical “OU cop-out” where the men-in-black arrived, or the 
inventor was poisoned, or the antigravity device broke through the roof, or in 
the case of Gene Mallove – murdered in a purely coincidental tragedy. There are 
some coincidences in life. 

 

BTW – Gene knew Arthur, and all of this is taking place in southern New 
Hampshire within a short radius of where Les Case also died unexpectedly and 
Rossi’s lab was located and several other alternative energy “coincidences”.

 

From: Bob Higgins 

 

There is also such a thing as a thermomagnetic heat pump.  It is usually 
envisioned with moving magnets.  However, just as one can imagine a moving 
magnetic field from a 3-phase drive producing a linear magnetic motor, one can 
envision a motion-less thermomagnetic heat pump in a ferrite.  There may be a 
thermomagnetic heat pumping effect involved in the cooling effect of the core.

 

Bob

 

On Fri, Aug 22, 2014 at 11:13 AM, Jones Beene <[email protected]> wrote:

                From: Bob Higgins

I am convinced of this connection: if one can document a cooling effect in a
transformer core which should be heating up (but instead is significantly
below ambient during operation) then that physical property is strong
indication of electrical gain. This was documented in the Manelas device.

Jones

 

Reply via email to