Hi Mathieu,
I also do not know why lilo work but grub doesn't. But it is based on
my experience and some reported problems. See this thread:
http://thread.gmane.org/gmane.linux.distributions.voyage.general/2276
Regards,
Punky
Mathieu Simon wrote:
Hi Punky and all who tried helping me
Indeed, switching from grub to lilo made it. Why?!
I have a usb cardreader, which could also have caused some
disturbances and the darn usb automounting of my xfce desktop. I had
less strange output during format-cf.sh using in console-only mode
than in xfce, but grub didn't work as well. I checked too, if the
partition was set bootable, and it was. Strange... My system is lenny
(testing), could it be that it only works with etch?
I hope that the rest will work as well and hope voyage will be growing
further.
Big thx for all the answers and hints!
Mathieu
2008/7/28 Kim-man 'Punky' TSE <[EMAIL PROTECTED]
<mailto:[EMAIL PROTECTED]>>
If you can't get the grub prompt, you can try the lilo as a
bootloader and see if it works. This sometimes happens if you are
running voyage.update on a non-Debian host for installing to CF.
Regards,
Punky
--
Regards,
Punky
Voyage Solutions (http://solution.voyage.hk)
* Embedded Solutions and Systems
- Mesh Networking, Captive Portal, IP Surveillance, VoIP/PBX
- Network Engineering, Development Platform and Consultation
_______________________________________________
Voyage-linux mailing list
[email protected]
http://list.voyage.hk/mailman/listinfo/voyage-linux
