On Sunday, November 22, 2020 at 1:11:15 PM UTC-8 [email protected] wrote: > CentOS 7.9 64bit clean install > Directions on http://weewx.com/docs/redhat.htm don't result in a workable > weewx. > Note- those instructions do NOT have a step for wee_config --install > Starting weewx installation over from scratch.... > Below is a complete transcript. One IMPORTANT thing to notice is the > "installed drivers" output section seems to show there are a LOT of missing > driver components!!!! > ALL of these steps are 100% repeatable. Variants using "wee_config > --reconfigure" result in the SAME failures! > Anyone know who the creator of the rpm repo is?? > Any help would be appreciated. > > The rpm comes from the weewx team.
Your 'no module named usb' and 'no module named serial' and the seemingly missing things are because you didn't have all the prerequisite python modules (rpms) installed. This is a longstanding known thing that has bitten many people over the years. You have to install the prerequisites. Unfortunately CentOS is weird a. I did a lot of testing of this in the v4 pre-release timeframe but did most of it using the setup.py (not rpm) method of installation. If you give me a couple hours I can probably do a quick test in a VM both ways to reverify vs. Centos-7.9 -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-user/7f1b816d-8c81-4eb3-8f96-0939384711cdn%40googlegroups.com.
