Do the report in performance reports and use mstask to kick it off at the cli.
James McGovern Amann Network Technician Lead Georgia State University IST / UCCS 95 Decatur St. Suite 500 Atlanta, GA 30303 PH: 404.651.1574 FX: 404.651.4408 PG: 404.476.7754 [EMAIL PROTECTED] >>> [EMAIL PROTECTED] 12/12/02 02:45PM >>> I am trying to post an uptime report to the web once a month every month. I am trying to set up a recurring notification to do this. In the recurring notification configuration section it will only allow you to run the notification every x minutes, with a maximum of 9999 minutes. One month is approximately 44640 minutes depending on how many days are in a month (31, 30, 29, 28). Does anyone have any suggestions on how to run this report automatically. Thanks, Frank Hobgood, CCNA, NNCDS, SCP DSM Pharmaceuticals Network Analyst II Disclaimer 1. This e-mail is for the intended recipient only. If you have received it by mistake please let us know by reply and then delete it from your system; access, disclosure, copying, distribution or reliance on any of it by anyone else is prohibited. 2. If you as intended recipient have received this e-mail incorrectly, please notify the sender (via e-mail) immediately. This e-mail is confidential and may be legally privileged. DSM does not guarantee that the information sent and/or received by or with this e-mail is correct and does not accept any liability for damages related thereto. Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/ Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
