Chris, What do you have in Configure > Program Options > General category, in the section Master Switches? If the 'Enable Status Polling....' is not enabled, that could be your problem!
Dan Donnelly ----- Original Message ----- From: "Chris Ohm" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Thursday, October 09, 2003 3:59 PM Subject: [WhatsUp Forum] Polling Issues Has anyone ever experienced the following: Config - Windows 2000 server with WUG 8.01 HotFix1 I have the WUG console open with 2 small maps displayed. Polling stops unless I have one of the pull down menus open. i.e. Click on 'Tools'. Polling also does not take place when WUG is run as a service. I have un-installed/re-installed the software, re-created the maps, etc. Very frustrating. Thanks for your help. Chris Ohm Systems Administrator American Specialty Health Inc. [EMAIL PROTECTED] ----------------------------------------- CONFIDENTIALITY NOTICE: This e-mail, and any attachments, are intended solely for the use of the intended recipient and may contain information that is confidential, proprietary, copyrighted and/or legally privileged. Any unauthorized disclosure, distribution, or use of this information is prohibited. If you are not the intended recipient, and have received this message in error, please notify the sender immediately by reply e-mail and destroy all copies of the original message and any attachments. Your compliance is appreciated. Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/ Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
