Jeff,
Sounds like you have a device with no active monitors (device is gray and
status is unknown). You could put the device into maintenance mode:
Device Properties>Polling>Maintenance>Force this device....
I'm not sure what affect leaving something with an unknown status does to
your reports, but I do know Maintenance mode is accounted for properly.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Thanks,
Steve Busby
Information Technology Services
University of Nebraska Medical Center
985030 Nebraska Medical Center
[EMAIL PROTECTED]
402.559.9621
If Linux doesn't have the solution, you have the wrong problem.
***************University of Nebraska Medical Center E-mail Confidentiality
Disclaimer ***************
The information in this e-mail is privileged and confidential, intended
only for the use of the addressee(s) above.
Any unauthorized use or disclosure of this information is prohibited. If
you have received this e-mail by mistake
please delete it and immediately contact the sender.
"Jeff Cook"
<[EMAIL PROTECTED]
om> To
Sent by: <[EMAIL PROTECTED]>
WhatsUp_Forum-own cc
[EMAIL PROTECTED]
com Subject
[WhatsUp Forum] WUP Status
11/12/04 08:01 PM
Please respond to
[EMAIL PROTECTED]
t.ipswitch.com
In WUG you would set a device to be unmonitored. How do you do this in
WUP? I see a status of unknown, but in WUG there was also a status of
inactive.
Thank You
Jeff Cook
Network Administrator
Whatcom Educational Credit Union
Please visit http://www.ipswitch.com/support/mailing-lists.html
to be removed from this list.
An Archive of this list is available at:
http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
