I'm trying to setup SNMP traps could use a little bit of help. I have the
traps setup on one particular switch, but I can't isolate an up/down
change for a specific interface. For example, I can tell that a port went
up or down, but I can't tell -which- port went up/down. Yes, I can setup
and monitor by syslog and write some expressions to match individual
interfaces, but I'd rather just get the traps setup properly.
Am I trying something that's just not possible?
Steve Creel
[EMAIL PROTECTED]
Please visit http://www.ipswitch.com/support/mailing-lists.html
to be removed from this list.
An Archive of this list is available at:
http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
