If you have a switch you might be able to discover additional interfaces which would represent each individual port. Then when a port went up/down so would the corresponding interface. Might not need SNMP at all.
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Steve Creel Sent: Thursday, December 02, 2004 2:33 PM To: [EMAIL PROTECTED] Subject: [WhatsUp Forum] SNMP Traps for Link State I'm trying to setup SNMP traps could use a little bit of help. I have the traps setup on one particular switch, but I can't isolate an up/down change for a specific interface. For example, I can tell that a port went up or down, but I can't tell -which- port went up/down. Yes, I can setup and monitor by syslog and write some expressions to match individual interfaces, but I'd rather just get the traps setup properly. Am I trying something that's just not possible? Steve Creel [EMAIL PROTECTED] Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/ Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
