Hi, So as I last mentioned I am able to see the "wmx0" interface when I type ifconfig. Now I have run into a new issue. I installed the Intel Binary Supplicant and Network Service. However when I enter "/etc/init.d/wimax start" the service starts up then stops running after a few seconds. Without this daemon running I cannot issue any wimaxcu commands. Any ideas? Thanks, Brandon
--- On Wed, 11/18/09, Brandon Dell <[email protected]> wrote: From: Brandon Dell <[email protected]> Subject: Re: Intel 5350 Firmware Download Issue To: "Jerone Young" <[email protected]>, "Inaky Perez-Gonzalez" <[email protected]> Cc: [email protected] Date: Wednesday, November 18, 2009, 7:14 AM Hi all, Yesterday I rebuilt my kernel using 2.6.29 from kernel.org and the card is being recognized now. I am going to investigate what differences, if any, there are between 2.6.29 and 2.6.31. Thanks for all you guys' help, Brandon --- On Tue, 11/17/09, Inaky Perez-Gonzalez <[email protected]> wrote: From: Inaky Perez-Gonzalez <[email protected]> Subject: Re: Intel 5350 Firmware Download Issue To: "Jerone Young" <[email protected]> Cc: "Brandon Dell" <[email protected]>, [email protected] Date: Tuesday, November 17, 2009, 5:48 PM On Tue, 2009-11-17 at 14:56 -0600, Jerone Young wrote: > Are you testing with kernels 2.6.31 & greater? Apparently according to > Kevin it works with 2.6.30 & below. Yeap, I do. my tree is in 2.6.32-rc3 -----Inline Attachment Follows----- _______________________________________________ wimax mailing list [email protected] http://lists.linuxwimax.org/listinfo/wimax
_______________________________________________ wimax mailing list [email protected] http://lists.linuxwimax.org/listinfo/wimax
