> On Thu, 2009-11-19 at 04:30 -0800, Brandon Dell wrote:
> Dan,
> I thought the "/etc/init.d/wimax {start|stop|status}" command was how
> you run it manually. Or am I mistaken?See Inaky's instructions. It is *one* way to run it manually as a system service. But that doesn't give you all the details if the service crashes or quits. Running it manually without the initscript indirection permits you to see all the output and figure out why the service is stopping early. Dan > > -Brandon > > --- On Wed, 11/18/09, Dan Williams <[email protected]> wrote: > > > From: Dan Williams <[email protected]> > Subject: Re: Intel 5350 Firmware Download Issue > To: "Brandon Dell" <[email protected]> > Cc: "Inaky Perez-Gonzalez" <[email protected]>, > [email protected] > Date: Wednesday, November 18, 2009, 4:27 PM > > > On Wed, 2009-11-18 at 11:47 -0800, Brandon Dell wrote: > > Hi, > > So as I last mentioned I am able to see the "wmx0" interface when > I type ifconfig. Now I have run into a new issue. I installed the > Intel Binary Supplicant and Network Service. However when I enter > "/etc/init.d/wimax start" the service starts up then stops running > after a few seconds. Without this daemon running I cannot issue any > wimaxcu commands. > > > > Any ideas? > > Have you tried running the service manually to find out why it's > quitting? > > Dan > > > Thanks, > > Brandon > > > > --- On Wed, 11/18/09, Brandon Dell <[email protected]> wrote: > > > > > > From: Brandon Dell <[email protected]> > > Subject: Re: Intel 5350 Firmware Download Issue > > To: "Jerone Young" <[email protected]>, "Inaky > Perez-Gonzalez" <[email protected]> > > Cc: [email protected] > > Date: Wednesday, November 18, 2009, 7:14 AM > > > > Hi all, > > Yesterday I rebuilt my kernel using 2.6.29 from kernel.org and the > card is being recognized now. I am going to investigate what > differences, if any, there are between 2.6.29 and 2.6.31. > > > > Thanks for all you guys' help, > > Brandon > > > > --- On Tue, 11/17/09, Inaky Perez-Gonzalez <[email protected]> > wrote: > > > > > > From: Inaky Perez-Gonzalez <[email protected]> > > Subject: Re: Intel 5350 Firmware Download Issue > > To: "Jerone Young" <[email protected]> > > Cc: "Brandon Dell" <[email protected]>, > [email protected] > > Date: Tuesday, November 17, 2009, 5:48 PM > > > > On Tue, 2009-11-17 at 14:56 -0600, Jerone Young wrote: > > > Are you testing with kernels 2.6.31 & greater? Apparently > according to > > > Kevin it works with 2.6.30 & below. > > > > Yeap, I do. my tree is in 2.6.32-rc3 > > > > > > > > > > > > > > > > > > -----Inline Attachment Follows----- > > > > _______________________________________________ > > wimax mailing list > > [email protected] > > http://lists.linuxwimax.org/listinfo/wimax > > > > > > > > _______________________________________________ > > > wimax mailing list > > > [email protected] > > > http://lists.linuxwimax.org/listinfo/wimax > _______________________________________________ wimax mailing list [email protected] http://lists.linuxwimax.org/listinfo/wimax
