On Sat, 2012-01-14 at 12:06 -0600, Ted Salmon wrote: > > My config.xml has an entry for: > > 6000 > I believe this value is miliseconds so I set it to 86400000 > > Maybe that is what you are looking for? > > > > I believe you can also create /etc/modprobe.d/i2400m.conf containing: > > options i2400m idle_mode_disabled=1 > > to disable idle mode entirely... > I tried this as well, unfortunately the driver randomly ignored this setting. > Either way the issue was resolved by setting an impossibly high idle timeout. > Thanks :).A word to all Clear(wire)/Other MVNO users - If you maintain your > realm as welcome.clearwire-wmx.net, etc you will NOT receive proper SLA > assignments (you will be limited to 5.5 mbps down and 512kbps up) - remove > the 'welcome' prefix from all realms in the WiMAX_DB.bin file. > Now, onto trying to figure out how to get my cards TX Power above .5 > milliwatts and sorting through the daemon's source!
Note that if you don't remove the "welcome." part you may never get past the VLAN landing page too; you'll be in a loop where it always says "we have an important message for you" and you can't ever get to the actual internet. Dan _______________________________________________ wimax mailing list [email protected] http://lists.linuxwimax.org/listinfo/wimax
