Really?? What models? We only use 5.8GHz and when we looked at Canopy in the past they where expensive and had limited throughput.
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of G.Villarini Sent: 18 January 2006 10:53 To: 'WISPA General List' Subject: RE: [WISPA] Multiple Radios on Single antenna Canopy isnt economic viable? Hmmm you can buy SM's @ $250 or less... and now the SM lite is out around $175. Its a tough call not to use Canopy. Gino A. Villarini, Aeronet Wireless Broadband Corp. [EMAIL PROTECTED] www.aeronetpr.com 787.273.4143 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Paul Hendry Sent: Wednesday, January 18, 2006 5:43 AM To: 'WISPA General List' Subject: RE: [WISPA] Multiple Radios on Single antenna Bob, I hear what you're saying and have been through the figures a few times and even tried turning the power of the radio cards down to 1dB output (still unable to run both links simultaneously) but this doesn't explain why others are able to use the same radio cards with similar antennas with little to no problems. Charles, unfortunately Canopy isn't a financially viable solution at present. I have a rough idea of these 2 terms but I'll research them a little deeper to see if they shed some light. Anything else that may help on my quest? -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Bob Moldashel Sent: 18 January 2006 00:25 To: WISPA General List Subject: Re: [WISPA] Multiple Radios on Single antenna Ahhhhh......Lets do some math....... Lets say the radio has a +20 dB output. For this example there is no line loss. The antenna is rated at 30dB x-pole isolation. Here we go... +20 dB -30dB xpole = -10 dB receive level. In my book that is high enough to kill any link of the same freq on the opposite polarity....No??? Add to that a radio that needs to Rx and Tx on and off and you should have receiver blocking....... -B- Matt Liotta wrote: > Depending on various factors, you should see at least 15db of > attenuation between polarizations on a dual-pol antenna. > Theoretically, you should see 20db. In any case, 15db is enough > attenuation even on the same channel to operate two links reliably. > > -Matt > > Jason Wallace wrote: > >> List, >> >> When antennas are separated by normal distances, they can only "see" >> each other electromagnetically (ie, radio waves). However, when they >> are close they will experience capacitive and inductive coupling. >> Dual pol antennas work fine when only receiving (as in those large >> satellite dishes from the 80's that used 90° pol changes between >> adjacent channels). I think you will always have trouble overloading >> the receiver when transmitting with this setup. > > > -- Bob Moldashel Lakeland Communications, Inc. Broadband Deployment Group 1350 Lincoln Avenue Holbrook, New York 11741 USA 800-479-9195 Toll Free US & Canada 631-585-5558 Fax 516-551-1131 Cell -- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/ -- No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.1.375 / Virus Database: 267.14.19/231 - Release Date: 16/01/2006 -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.375 / Virus Database: 267.14.20/233 - Release Date: 18/01/2006 -- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/ -- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/ -- No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.1.375 / Virus Database: 267.14.20/233 - Release Date: 18/01/2006 -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.375 / Virus Database: 267.14.20/233 - Release Date: 18/01/2006 -- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/