Has anyonoe tested the amount of self interference created between two
MiniPCI RF cards mounted in the same box in the same spectrum range?
Does the connector bleed RF? My original thought for multi-Slot boards
(Mikroti/WAR) was that if I wanted to put in 4 cards, I could put in a 2.4,
900, 5.3, and 5.8G all in the same box without self interference since they
were in different spectrum ranges.
But can two cards be put in, within the same range (Qty 2- 5.3Ghz cards for
example) without interference?
Tom DeReggi
RapidDSL & Wireless, Inc
IntAirNet- Fixed Wireless Broadband
----- Original Message -----
From: "Travis Johnson" <[EMAIL PROTECTED]>
To: "WISPA General List" <wireless@wispa.org>
Sent: Saturday, November 18, 2006 11:09 PM
Subject: Re: [WISPA] SR9 problems..
Hi,
I wouldn't recommend more than one SR9 per RB532. They draw a lot of
power, and you will probably burn up your RB after a while.
Also, there is a frequency conversion chart in the Mikrotik forums on how
the 2.4ghz channels translate to the 900mhz channels. Mikrotik will be
fixing this in the 3.0 release.
Travis
Microserv
J. Vogel wrote:
I finally got a chance to play with the SR9 cards I got in last week.
Installed them
in a RB532 running 2.9.30, along with one Prism nl-2511mp plus and a
RouterBoard r52 (Atheros chipset?). Not working.
First off, the SR9s are big enough that they don't fit everwhere you
might think they
should... such as on the top side of a RB112. Neither do they fit in one
of the two
slots in the expansion daughterboard for a RB532. Swapping cards around,
I did
get the two SR9s in with the other two cards above. One is on the
daughterboard,
the other is (I think) on the back side of RB532. Fired up the system,
and it shows
four wireless interfaces. The Prism, and the rb52 (which shows up as
Atheros AR5413)
both work, am able to configure them and pass traffic through them as
desired.
The other two interfaces are listed as AR5213 cards. Is that correct?
When I
attempt to configure those interfaces (using winbox) the only option I
have available
for the RF band is 2.4Ghz, along with the B,G 10mHz and 5 mHz options in
that
band. Channels 1 through 11 in the 2.4 range are available for me to
select. Nothing
about 900 mHz.
What am I doing wrong?
John
--
WISPA Wireless List: wireless@wispa.org
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
--
WISPA Wireless List: wireless@wispa.org
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
