Seems to me that the 200mw cards in the past had issues being so loud
and close, but the atheros cm9's close have not been an issue for me. As
I recall, the higher powered cards I used ch 1 and ch 11.
Now my pops are 5 gig and 2 gig and I don't notice any problems.
George
Tom DeReggi wrote:
Has anyonoe tested the amount of self interference created between two
MiniPCI RF cards mounted in the same box in the same spectrum range?
Does the connector bleed RF? My original thought for multi-Slot boards
(Mikroti/WAR) was that if I wanted to put in 4 cards, I could put in a
2.4, 900, 5.3, and 5.8G all in the same box without self interference
since they were in different spectrum ranges.
But can two cards be put in, within the same range (Qty 2- 5.3Ghz cards
for example) without interference?
Tom DeReggi
RapidDSL & Wireless, Inc
IntAirNet- Fixed Wireless Broadband
----- Original Message ----- From: "Travis Johnson" <[EMAIL PROTECTED]>
To: "WISPA General List" <[email protected]>
Sent: Saturday, November 18, 2006 11:09 PM
Subject: Re: [WISPA] SR9 problems..
Hi,
I wouldn't recommend more than one SR9 per RB532. They draw a lot of
power, and you will probably burn up your RB after a while.
Also, there is a frequency conversion chart in the Mikrotik forums on
how the 2.4ghz channels translate to the 900mhz channels. Mikrotik
will be fixing this in the 3.0 release.
Travis
Microserv
J. Vogel wrote:
I finally got a chance to play with the SR9 cards I got in last week.
Installed them
in a RB532 running 2.9.30, along with one Prism nl-2511mp plus and a
RouterBoard r52 (Atheros chipset?). Not working.
First off, the SR9s are big enough that they don't fit everwhere you
might think they
should... such as on the top side of a RB112. Neither do they fit in one
of the two
slots in the expansion daughterboard for a RB532. Swapping cards around,
I did
get the two SR9s in with the other two cards above. One is on the
daughterboard,
the other is (I think) on the back side of RB532. Fired up the system,
and it shows
four wireless interfaces. The Prism, and the rb52 (which shows up as
Atheros AR5413)
both work, am able to configure them and pass traffic through them as
desired.
The other two interfaces are listed as AR5213 cards. Is that correct?
When I
attempt to configure those interfaces (using winbox) the only option I
have available
for the RF band is 2.4Ghz, along with the B,G 10mHz and 5 mHz options in
that
band. Channels 1 through 11 in the 2.4 range are available for me to
select. Nothing
about 900 mHz.
What am I doing wrong?
John
--
WISPA Wireless List: [email protected]
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
--
George Rogato
Welcome to WISPA
www.wispa.org
http://signup.wispa.org/
--
WISPA Wireless List: [email protected]
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
