I figure about 15 minutes for an RB112 / mikrotik / SR5 and SR2 cards w/cables, exterior cables, and antenna hookup / testing.
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Tom DeReggi Sent: Tuesday, December 19, 2006 1:52 PM To: WISPA General List Subject: [WISPA] Building WARboard radios On average, how long does it take, to build a WAR/rootenna radio system, start to finish. Or I should say, how much time should the manager allocate for the process to be complete by their techs. Lets define some common variables.... Say the tech is building 5 at a time, of the same configuration. Assume that its mounting equipment that does not come as a complete kit, meaning the follow ing variable could occurs.... Need to find the correct standoffs. Net to cut sheet metal and drill holes for backplane. Need to power up and teset radio. Boards are WAR board preloaded with Firmware. PS. The WAR boards have narrower diameter mounting hole, and the typical coarse thread gold PC stand-offs are to wide and thread into the hole in appropriately. Any one have a source for the fine thread narrower diameter standoffs and nuts? Tom DeReggi RapidDSL & Wireless, Inc IntAirNet- Fixed Wireless Broadband -- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/ -- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
