On 30/01/2006, at 8:14 AM, Chris Kennon wrote:
http://working.bushidodeep.com/remix/remix_bg.jpg
The plan is the very back (the textured back ground) is the container_bg, the cards are the content_bg, and my question was on properly slicing up the tabs along the right side of the cards, for use as navigation,

Ah, my apologies - I didn't even *see* the tabs :(
I think my first attempt would to cut the image into 5 pieces:
- the entire left hand side
- top right hand piece, including top tab
- 2 x middle tabs, out to right hand edge of image
- bottom right hand piece, including bottom tab.

This gives the minimum number of pieces to apply to elements.
Hmmm... although thats going to make the anchor over the large pieces difficult...

OK, second try:
I would cut it into 6 pieces:
- the left hand piece, to the edge of the top piece of paper
- the right hand piece, from that edge to the right hand edge of the image *and do some clever editing so the tabs dont appear* - then one piece for each tab. This would overlay the large right hand piece I assume the tab sticking out further is the current one - a separate image for that. Not sure if I would make the list item containing the tab the size of the larger tab or the size of the smaller one, I would have to experiment.

Does that help more?
:)

warmly,
Lea
--
Lea de Groot
Brisbane, Australia
******************************************************
The discussion list for  http://webstandardsgroup.org/

See http://webstandardsgroup.org/mail/guidelines.cfm
for some hints on posting to the list & getting help
******************************************************

Reply via email to