On 28/05/2015 15:45, Joe Taylor wrote: > Hi Bill, Greg, and all, Hi All, > > I have addressed the issues that Bill found. I'm happy with the User > Guide as it now stands, with one possible exception -- the piece I added > about kvasd-installer for Linux, at the end of Section 3.2: > > http://www.physics.princeton.edu/pulsar/K1JT/wsjtx-doc/wsjtx-main-1.6.0-devel.html#INSTALL_LINUX > > Probably this could use some work. I have merged the required change sets up to r5442 into the wsjtx-1.5 branch so that it also builds a user guide.
I will look into the issue Laurie & Mike have reported with the UDP message responses and see is a fix is necessary in v1.5 for that. Greg is probably the best/only person who can quickly respond on the KVASD installer for Linux. If there are any more user guide changes for v1.5 they will now have to be merged into the trunk/branch, I will watch the trunk for changes and merge them myself if anyone is unfamiliar with cherry-pick merging. I think we are now very close to a v1.5.0-rc2 release. > > -- Joe 73 Bill G4WJS. > > On 5/28/2015 8:28 AM, Bill Somerville wrote: >> On 27/05/2015 21:17, Joe Taylor wrote: >>> Hi all, >> Hi Joe, >>> With SVN revision 5427 I have committed files to build the WSJT-X User >>> Guide for Version 1.5. I would greatly appreciate a careful reading by >>> others! Please report mistakes, typos, unclear text, or any other need >>> for improvements to this list. >> Reviewing the user guide I see the following issues: >> >> The link http://physics.princeton.edu/pulsar/K1JT/kv-installer.txt is >> referenced but doesn't yet exist. >> >> The anchor >> file:///C:/build/wsjtx-dev/Debug/doc/wsjtx-main.html#COMP_CALL is >> referenced but doesn't exist. >> >> Sect. 4.2 Radio - CAT Control - Force Control Lines should now say >> something like: >> "A few station setups require the CAT serial port’s *RTS* and/or *DTR* >> control lines to be forced high or low. Check these boxes only if you >> are sure they are needed." >> >> Sect. 4.2 Radio - CAT Control - PTT Method - should say: >> "... select the desired serial port which may be the same one as used >> for CAT control." >> >> Sect.6.1 Main Window Settings - here and elsewhere it may be helpful to >> mention that the sliders and spin box controls in WSJT-X respond to both >> arrow key presses and and Page UP/Down key presses with the page keys >> moving in larger increments. >> >> Sect. 6.2 Wide Graph Settings - Gain - spurious ','. >> >> Sect. 8.3 Misc Controls Left - the Icom rigs warning should be extended >> to say something like: >> "Many Icom rigs cannot be queried for split status, current VFO nor >> split transmit frequency, so you should not change the current VFO, >> split status or frequency using rig controls when using /WSJT-X/." >> >> Sect 8.4 Misc Controls Center - broken link in the first bullet point. >> >> 73 >> Bill >> G4WJS. ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
