Hi Bill,
> Is 40m a band where your auto ATU has to do some work? I suspect that
> the TS-2000 goes busy on the CAT port while it is tuning. It may be that
> Hamlib needs to allow for even more retries than it currently does when
> recovering from this condition.
I don't use the ATU in the TS-2000; I use an external wide-range unit.
> There is a similar situation with older Kenwoods like the TS-440 which
> goes busy while it generates the audio CW id on mode changes :(
>> Usually it recovers on the retry, but perhaps not always?
> A hard rig control error would result in cancelling auto Tx but it
> should leave a message box on the screen.
Yes, I was forgetting that. There was no message box.
>> The Hamlib problems are exacerbated when I try to run my
>> bare-bones-and-incomplete Echo mode. The test cycle with Doppler
>> corrections enabled means retuning the radio twice every 6 seconds.
>> Even at 57600 baud, the TS-2000 too often fails to get a message.
> I would like to see the Hamlib trace from that. Retuning twice in 6
> seconds should be no problem at all, there is something going wrong
> other than timing and CAT baud rates.
I agree. I will do more testing...
-- Joe
------------------------------------------------------------------------------
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
