(Fair warning: I may not be fully awake ...)
I have now reproduced essentially what Eric reported by doing the
following steps:
1. Start WSJT-X in WSPR mode
2. Run a short Tune cycle (click Tune twice)
3. Click Tx Enable
If Step 2 is omitted, I do NOT see what Eric reported. The program
behaves as expected.
Eric, are you always running a Tune cycle? Please try it without using
Tune.
We'll figure out what's going on...
-- Joe, K1JT
On 6/10/2015 9:10 PM, Joe Taylor wrote:
> Hi Eric,
>
> On 6/10/2015 6:49 PM, Eric NO3M wrote:
>> Having problems with WSPR2 TX here.
>>
>> WSJTX 1.6.0-devel r5578 (same problems with r5567 also before doing SVN
>> update/re-compile)
>> Band: 630m
>> Tx 1575 Hz
>> Tx Pct 33%
>> Upload Spots = true
>> Band Hopping = false
>>
>> As soon as I click Tx Enable, regardless of how far into a 2-minute
>> period it is clicked, WSJTX immediately starts transmitting the WSPR
>> message.
>
> Try as I will, I cannot reproduce the behavior you describe.
>
> When I start WSJT-X in WSPR-2 mode and click Tx Enable, the program
> politely waits for the start of an even-numbered minute. It then begins
> a normal cycle. This cycle ends at the normally expected time, 54
> seconds into an odd-numbered minute.
>
> If I start the program, toggle Tx Next to ON, and then click Tx Enable,
> the behavior is the same except that the first full 2-minute sequence is
> Tx rather than Rx.
>
> I am presently baffled by your report.
>
> -- 73, Joe, K1JT
>
> ------------------------------------------------------------------------------
> _______________________________________________
> wsjt-devel mailing list
> wsjt-devel@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/wsjt-devel
------------------------------------------------------------------------------
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
