Joe, Steve, et.al. Yes, I was engaging Tune prior to clicking "Tx Enable", generally to make sure the match on my 630M antenna is alright (very narrow bandwidth) and that output power is correct for 5W EIRP. It is such a habit that apparently I do it everytime I start WSJT-X!
I restarted WSJT-X and did NOT engage Tune prior to clicking "Tx Enable". Behavior appears to be normal, a TX cycle with audio fired off on the next even minute and returned to Monitor on the following 2-minute period, after a couple cycles of RX, another TX cycle started (with tones), then back to RX. Exactly the expected behavior. 73 Eric On 06/10/2015 09:31 PM, Joe Taylor wrote: > (Fair warning: I may not be fully awake ...) > > I have now reproduced essentially what Eric reported by doing the > following steps: > > 1. Start WSJT-X in WSPR mode > 2. Run a short Tune cycle (click Tune twice) > 3. Click Tx Enable > > If Step 2 is omitted, I do NOT see what Eric reported. The program > behaves as expected. > > Eric, are you always running a Tune cycle? Please try it without using > Tune. > > We'll figure out what's going on... > > -- Joe, K1JT > > > On 6/10/2015 9:10 PM, Joe Taylor wrote: >> Hi Eric, >> >> On 6/10/2015 6:49 PM, Eric NO3M wrote: >>> Having problems with WSPR2 TX here. >>> >>> WSJTX 1.6.0-devel r5578 (same problems with r5567 also before doing SVN >>> update/re-compile) >>> Band: 630m >>> Tx 1575 Hz >>> Tx Pct 33% >>> Upload Spots = true >>> Band Hopping = false >>> >>> As soon as I click Tx Enable, regardless of how far into a 2-minute >>> period it is clicked, WSJTX immediately starts transmitting the WSPR >>> message. >> Try as I will, I cannot reproduce the behavior you describe. >> >> When I start WSJT-X in WSPR-2 mode and click Tx Enable, the program >> politely waits for the start of an even-numbered minute. It then begins >> a normal cycle. This cycle ends at the normally expected time, 54 >> seconds into an odd-numbered minute. >> >> If I start the program, toggle Tx Next to ON, and then click Tx Enable, >> the behavior is the same except that the first full 2-minute sequence is >> Tx rather than Rx. >> >> I am presently baffled by your report. >> >> -- 73, Joe, K1JT >> >> ------------------------------------------------------------------------------ >> _______________________________________________ >> wsjt-devel mailing list >> wsjt-devel@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/wsjt-devel > ------------------------------------------------------------------------------ > _______________________________________________ > wsjt-devel mailing list > wsjt-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/wsjt-devel ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
