On 13/06/2015 18:25, Michael Black wrote: Hi Mike, > You can adjust the left edge of the waterfall in the WSPR instance That's > the "Start XXX Hz" entry. Just set it to 700 Hz. Then you can adjust the > Bins/Pixel to only see the WSPR band too. This is not a display issue, it depends on whether the WSPR decoder will decode signals away from the usual 1.5kHz +-100Hz zone. I am not in the shack and a quick glance at the code doesn't answer that question. Easy to try out with a receiver though. > > > 73 > Mike W9MDB 73 Bill G4WJS. > > > -----Original Message----- > From: Mike [mailto:[email protected]] > Sent: Saturday, June 13, 2015 12:02 PM > To: [email protected] > Cc: Mike > Subject: [wsjt-devel] -5578 dual WSPR and JT65/9 use via two instances. > > Hi, > Is there any way two instances of WSJTX can share the same audio on 30 > meters with one of them receiving the audio shifted by 700 Hz ? > > I run a JT65/9 monitor - it sits on 10.138 MHz, the WSRP region is 700 Hz > above that yet with another instance of WSJTX monitoring it always (as > expected) receives the 10.138 feed, is there a way to tell WSJTX to consider > the band start 700 Hz up, or via some kind of vfo offset? > > Alternative I can take the radio audio via a 700 Hz shift and output that to > a new pulseaudio sink which the other WSJTX in WSPR mode can use - but > thought to ask if a simple offset is possible first. > > Use case would be dual monitoring on 30 meters, both JTxx and WSPR. > > BR > Mike > OH2FCZ. > > > > ------------------------------------------------------------------------------ > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel
------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
