I may have missed an inferred step. #1 Start a transmit on JT9 #2 Halt #3 Double-click on JT65 event Still stays in JT9 mode.
That's not intended, is it? I don't recall previously ever having to touch the mode button unless I was CQ'ing and changing mode. Mike W9MDB On Tue, Nov 10, 2015 at 3:47 PM, Bill Somerville <g4...@classdesign.com> wrote: > On 10/11/2015 21:41, Michael Black wrote: > > Hi Mike, > > 1.6.1 r6058 > > > > #1 Start a transmit on JT9. > > #2 Double-click a JT65 entry in either window > > > > Mode does not switch to JT65 > This is the intended behaviour. The message content should not change > either. The transmit setup is only done at he start of a transmission > and is not corrected for mode changes, this is consistent with the mode > change button being disabled while transmitting. > > If you wish to change mode while transmitting then you must click "Halt" > then change mode then "Enable TX" again. > > Next transmit will be JT9 instead of JT65 (as expected since mode > > doesn't switch). > > > > Same behavior going the other way too. > Further restrictions are applied if you have QSY while transmitting set > in the settings, this is for rigs that cannot physically QSY while > transmitting (many Yaesus for example). > > > > Mike W9MDB > 73 > Bill > G4WJS. > > > ------------------------------------------------------------------------------ > _______________________________________________ > wsjt-devel mailing list > wsjt-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/wsjt-devel >
------------------------------------------------------------------------------
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
