On 10/11/2015 22:56, Michael Black wrote:
Hi Mike,
OK...try this...I just did this one.
Had a current JT9 CQ pop up.
Changed mode to JT65.
Double clicked the JT9 CQ
Transmit started doing JT9
That is a reproducible issue. The double-click decode processing is not
checking what mode is selected (mode in the mode menu) and simply doing
what it would in dual mode. This is probably wrong but TBH it is pretty
unlikely that there will be any "other" mode decodes to double-click in
normal single mode usage.
Mode button still shows JT65. Waterfall shows JT9 appropriately.
Shouldn't the mode button change?
I believe nothing at all should happen since single mode operating has
been selected, although changing mode is a possibility but that gets
complicated with mode dependent working frequencies.
73
Bill
G4WJS.
On Tue, Nov 10, 2015 at 4:38 PM, Bill Somerville
<g4...@classdesign.com <mailto:g4...@classdesign.com>> wrote:
On 10/11/2015 22:15, Michael Black wrote:
Hi Mike,
Yes....I can repeat this at will with that sequence. You don't
see that behavior?
Going either JT9->JT65 or the other way.
It may be that too much time has elapsed of the current period and
WSJT-X is refusing to change the message as it is too late to be
worth transmitting.
73
Mike W9MDB
73
Bill
G4WJS.
On Tue, Nov 10, 2015 at 4:06 PM, Bill Somerville
<g4...@classdesign.com <mailto:g4...@classdesign.com>> wrote:
On 10/11/2015 22:02, Michael Black wrote:
Hi Mike,
I may have missed an inferred step.
#1 Start a transmit on JT9
#2 Halt
#3 Double-click on JT65 event
Still stays in JT9 mode.
That's not intended, is it? I don't recall previously ever
having to touch the mode button unless I was CQ'ing and
changing mode.
That is not right - in that case it should have switched
mode, are you sure that the Tx had finished halting before
you double clicked a new decode?
Mike W9MDB
73
Bill
G4WJS.
On Tue, Nov 10, 2015 at 3:47 PM, Bill Somerville
<g4...@classdesign.com <mailto:g4...@classdesign.com>> wrote:
On 10/11/2015 21:41, Michael Black wrote:
Hi Mike,
> 1.6.1 r6058
>
> #1 Start a transmit on JT9.
> #2 Double-click a JT65 entry in either window
>
> Mode does not switch to JT65
This is the intended behaviour. The message content
should not change
either. The transmit setup is only done at he start of a
transmission
and is not corrected for mode changes, this is
consistent with the mode
change button being disabled while transmitting.
If you wish to change mode while transmitting then you
must click "Halt"
then change mode then "Enable TX" again.
> Next transmit will be JT9 instead of JT65 (as expected
since mode
> doesn't switch).
>
> Same behavior going the other way too.
Further restrictions are applied if you have QSY while
transmitting set
in the settings, this is for rigs that cannot physically
QSY while
transmitting (many Yaesus for example).
>
> Mike W9MDB
73
Bill
G4WJS.
------------------------------------------------------------------------------
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
