OK...try this...I just did this one. Had a current JT9 CQ pop up. Changed mode to JT65. Double clicked the JT9 CQ Transmit started doing JT9 Mode button still shows JT65. Waterfall shows JT9 appropriately. Shouldn't the mode button change?
On Tue, Nov 10, 2015 at 4:38 PM, Bill Somerville <g4...@classdesign.com> wrote: > On 10/11/2015 22:15, Michael Black wrote: > > Hi Mike, > > Yes....I can repeat this at will with that sequence. You don't see that > behavior? > Going either JT9->JT65 or the other way. > > It may be that too much time has elapsed of the current period and WSJT-X > is refusing to change the message as it is too late to be worth > transmitting. > > 73 > Mike W9MDB > > 73 > Bill > G4WJS. > > > On Tue, Nov 10, 2015 at 4:06 PM, Bill Somerville <g4...@classdesign.com> > wrote: > >> On 10/11/2015 22:02, Michael Black wrote: >> >> Hi Mike, >> >> I may have missed an inferred step. >> #1 Start a transmit on JT9 >> #2 Halt >> #3 Double-click on JT65 event >> Still stays in JT9 mode. >> >> That's not intended, is it? I don't recall previously ever having to >> touch the mode button unless I was CQ'ing and changing mode. >> >> That is not right - in that case it should have switched mode, are you >> sure that the Tx had finished halting before you double clicked a new >> decode? >> >> >> >> Mike W9MDB >> >> 73 >> Bill >> G4WJS. >> >> >> On Tue, Nov 10, 2015 at 3:47 PM, Bill Somerville < >> <g4...@classdesign.com>g4...@classdesign.com> wrote: >> >>> On 10/11/2015 21:41, Michael Black wrote: >>> >>> Hi Mike, >>> > 1.6.1 r6058 >>> > >>> > #1 Start a transmit on JT9. >>> > #2 Double-click a JT65 entry in either window >>> > >>> > Mode does not switch to JT65 >>> This is the intended behaviour. The message content should not change >>> either. The transmit setup is only done at he start of a transmission >>> and is not corrected for mode changes, this is consistent with the mode >>> change button being disabled while transmitting. >>> >>> If you wish to change mode while transmitting then you must click "Halt" >>> then change mode then "Enable TX" again. >>> > Next transmit will be JT9 instead of JT65 (as expected since mode >>> > doesn't switch). >>> > >>> > Same behavior going the other way too. >>> Further restrictions are applied if you have QSY while transmitting set >>> in the settings, this is for rigs that cannot physically QSY while >>> transmitting (many Yaesus for example). >>> > >>> > Mike W9MDB >>> 73 >>> Bill >>> G4WJS. >>> >> > > > ------------------------------------------------------------------------------ > > _______________________________________________ > wsjt-devel mailing list > wsjt-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/wsjt-devel > >
------------------------------------------------------------------------------
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
