Bill, I should have specified, yes that would be OK, however, when i use the frequencies above 2500 (e.g. JT9) it still stay at the base freq. I looked at the hamlib code, and there does not seem to be a different behavior for FT-991a vs. FT-991 supported there. My expectation would be that VFOb would jump to, say, 7077 if this is the Tx VFO.
Thanks JC W6IPA > On Mar 31, 2017, at 3:08 AM, Bill Somerville <[email protected]> wrote: > > On 31/03/2017 04:36, Jc Martin wrote: >> However, when i transmit, VFOa and VFOb are reset to the base frequency >> (using JT65/JT9 mode). > > Hi OM, > > can you more specific about what you think is not right? For example if > your Tx DF were set between 1500 Hz and 1999 Hz the behaviour you > describe sound correct to me. > > 73 > Bill > G4WJS. > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
