On 31/03/2017 18:07, Jc Martin wrote: > I should have specified, yes that would be OK, however, when i use the > frequencies above 2500 (e.g. JT9) it still stay at the base freq. > I looked at the hamlib code, and there does not seem to be a different > behavior for FT-991a vs. FT-991 supported there. > My expectation would be that VFOb would jump to, say, 7077 if this is the Tx > VFO.
HI JC, the change may not happen until you transmit. Can you do the following: 1) select 40m in JT9+JT65 mode, 2) ensure that "Settings->Radio->Split Operating" is set to "Rig" and click "Ok", 3) set your rig's display to show both the VFO frequencies, 4) CTRL+Click on the waterfall at least 500 Hz away from the current Tx cursor (red) position. You should see the Tx VFO frequency being changed whenever you do (4) above. Let us know if this is not happening and I will send you an instrumented version of WSJT-X that will allow me to see what is happening. 73 Bill G4WJS. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
