Joe - I used it last night for quite a while on several HF bands, and it worked very well. I didn't notice the Enable Tx button going off after the end of the QSO, but don't mind it staying on. In any case, this is a welcome and very useful feature - thanks!
Eric NC6K -----Original Message----- From: Joe Taylor [mailto:j...@princeton.edu] Sent: Monday, July 10, 2017 6:53 AM To: wsjt-devel@lists.sourceforge.net Subject: [wsjt-devel] Call 1st Hi all, I had not intended the "Weak" checkbox to be visible, just yet. Its function is not yet implemented. Code revision 7835 is yet another attempt to get the "Call 1st" logic just right. I think it should now do the following: 1. Decodes containing "MyCall" or falling within 10 Hz of RxFreq should appear in the right window. 2. If "Auto Seq" and "Call 1st" are checked and you have transmitted a CQ message, the first decode of someone calling you should behave as though you have double-clicked it. 3. When your QSO finishes, another CQ transmission should be queued up, but "Enable Tx" will be off. To continue running a frequency you must click "Enable Tx" again. Please report any misbehavior of this feature! We are getting close to a v1.8-rc1 release. -- Joe, K1JT ---------------------------------------------------------------------------- -- Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
