On 23/07/2017 11:20, John Nelson wrote:
Hi Bill,
In r7058: “Add a user control for Tx Delay, on the Advanced tab” to provide
sequencer protection for mast head pre-amps. The maximum value in the spinner
was 2secs.
At some point between r7295 and r7312 the maximum was reduced to 0.5s. There
is no mention of this change in History. Please could this maximum revert to
2s to provide some flexibility.
In Configuration.ui: sbTxDelay.. <property name="maximum”>
<double>0.500000000000000</double>
— John G4KLA
Hi John,
I changed it to 2s, temporarily, when there were issues with DX Lab
Commander rig control where audio was not being safely delayed until
after Commander reported PTT asserted. This has been resolved as far as
safety ic concerned, work is ongoing to speed up the overall time for
switching from Rx to Tx on some rigs using Commander as a rig control proxy.
Joe asked me to revert back to the original maximum value for Tx delay,
I agree with him, because if Rx to Tx latency is longer than 0.5 seconds
then that is too slow and it will start to degrade the sent messages.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
