Using 1.8.0-rC2 r8069
Under Settings, General tab, under 'Behavior', the "Disable TX after 73"
unchecked. However, when the Tx5 (73) message is sent, the log QSO box comes
up as it should, but the "Enable Tx" goes from red to gray. This disables
further transmissions until the "Enable Tx" button is clicked gain.
Shouldn't the system continue on to Tx6, and send the CQ message in the next
transmit sequence ?
Has this feature been eliminated or maybe I am misunderstanding what the check
box is supposed to do?
73,
Rich - K1HTV
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel