That's normal - user interaction to start another QSO is required to
prevent "QSO machines"
Jim S.
N2ADV
On 9/7/2017 7:49 PM, Rich - K1HTV wrote:
Using 1.8.0-rC2 r8069
Under Settings, General tab, under 'Behavior', the "Disable TX after
73" unchecked. However, when the Tx5 (73) message is sent, the log
QSO box comes up as it should, but the "Enable Tx" goes from red to
gray. This disables further transmissions until the "Enable Tx" button
is clicked gain.
Shouldn't the system continue on to Tx6, and send the CQ message in
the next transmit sequence ?
Has this feature been eliminated or maybe I am misunderstanding what
the check box is supposed to do?
73,
Rich - K1HTV
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
--
73,
Jim S.
N2ADV
www.qrz.com/db/N2ADV
https://www.facebook.com/groups/FT8.Digital.Mode/
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
