No does not work w rig option - it goes to the existing B vfo freq - not the fiddled freq from FT8. But it works correctly the FIRST transmission. On Dec 10, 2018, at 6:50 PM, Bill Somerville wrote:
> Hi Larry, > > does it work if you check the "Settings->Radio->Split Operating->Rig" option? > > 73 > Bill > G4WJS. > > On 10/12/2018 23:46, Lawrence Provost wrote: >> Hi Bill >> Audio is via homebrew xfmr iso from internal sound card. PTT is via the CAT >> connection. Cat connection is outboard USB to serial dongle into 9 pin CAT >> port on rear of rig. This all works FB except with FT8 split function via HRD >> \ >> >> On Dec 10, 2018, at 6:07 PM, Bill Somerville wrote: >> >>> On 10/12/2018 22:43, Lawrence Provost wrote: >>>> I have just upgraded to WSJT-X v2.0. I am operating FT8. When interfacing >>>> CAT through HRD and using "fake it" for the split HRD and the radio (Yaesu >>>> FT-450D) both change freq for transmit but only for the FIRST >>>> transmission. On subsequent transmissions HRD and the radio change for a >>>> moment, but then revert to the original freg. WSJT-X shows the split >>>> during the transmissions. (e.g. 7.074 000 changes to 7.074 500 when using >>>> the higher Tx freqs) If I change Tx freq things will work correctly again >>>> but only for the FIRST transmission >>>> >>>> Things work as expected if I interface the rig directly (without HRD >>>> running) >>>> >>>> Any ideas? >>>> >>> Hi Larry, >>> >>> how is your rig connected to your PC for audio PTT and CAT? >>> >>> 73 >>> Bill >>> G4WJS > > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
