Hil, You can also use the mouse wheel if available. 73, Sam W2JDB
-----Original Message----- From: Bill Somerville <[email protected]> To: [email protected] Sent: Mon, Feb 15, 2021 10:01 am Subject: Re: [wsjt-devel] Rc4 Tx levels will cause future QRM problems Hi David, you can already do that by selecting the slider and using the up and down arrow keys. Page up and down for 1 dB increments. 73 Bill G4WJS. On 15/02/2021 14:58, David Tiller wrote: You wrote: "How about adding a small "dB' box right under the "Pwr" label" If you add that (and I hope you do), please make it a spinner box so we can adjust it with up/down arrows by preferably 0.1 dB increments. On Feb 15, 2021, at 9:35 AM, Rich - K1HTV mailto:[email protected] wrote: I noticed that while running WSJT-X v2.4.0-rc1, the original WSJT-X "Pwr" control setting produced excessive AGC levels on my K3 transceiver. TX levels are over 5 dB higher with WSJT-X Version 2.4.0-rc1 than with previous versions. Unless a software change is made so TX audio levels match those of previous versions of WSJT-X, I'm afraid that we all will be hearing more kazoo sounds on the FT8 & FT4 frequencies and will be seeing more and more spurious signals on our Wide Graph screens. "Pwr" slider idea: Would it be possible to change the way to read the "Pwr" slider setting dB level? Presently, users must move the slider setting in order to check the dB level,We should be able to read the setting without having to change it. How about adding a small "dB' box right under the "Pwr" label I think that would make more sense than the way it is now. Can this change be implemented? 73, Rich - K1HTV _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
