(2.4.0_rc1 64 bit )
I too noticed a difference in TX audio levels when I first started to
use 2.4.0 RC1. In fact the change of levels was the same as the
difference in levels between the v2.2.2 32 bit vs. 2.2.2 64 bit ( ~8 db ).
But after 3 days of using 2.4.RC1 with the higher level, for some
unknown reason that I have not yet identified, the level reverted to
what I had in 2.3.0. And they have stayed there since.
Unexplained changes on my PC make me feel uneasy.
AL, K0VM
On 2/15/2021 8:35 AM, Rich - K1HTV wrote:
I noticed that while running WSJT-X v2.4.0-rc1, the original WSJT-X
"Pwr" control setting produced excessive AGC levels on my K3
transceiver. TX levels are over 5 dB higher with WSJT-X Version
2.4.0-rc1 than with previous versions.
Unless a software change is made so TX audio levels match those of
previous versions of WSJT-X, I'm afraid that we all will be hearing
more kazoo sounds on the FT8 & FT4 frequencies and will be seeing more
and more spurious signals on our Wide Graph screens.
"Pwr" slider idea:
Would it be possible to change the way to read the "Pwr" slider
setting dB level? Presently, users must move the slider setting in
order to check the dB level,We should be able to read the setting
without having to change it.
How about adding a small "dB' box right under the "Pwr" label I think
that would make more sense than the way it is now. Can this change be
implemented?
73,
Rich - K1HTV
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
