On 17/02/2021 15:03, Dirk Kuschke via wsjt-devel wrote:
Hello,
since FTDX version 2.3.0
my yaesu ftdx3000d changes to split mode when I change the frequency,
using the button on the left. Up to version WSJTX2.2.2 this was not
the case.
The settings are:
Inline-Bild Inline-Bild
I change the Databits between 7 or 8 and the Stop bits between 1 or 2
with
no effect. The correct setting Databit 8 and 2 Stop bits lt. Yaesu UK.
In the settings i also change the radio to Yaesu FT-950 with the same
affect change to split mode….
73, Dirk
Hi Dirk,
if this is happening when you change bands then it is because SPLIT was
set the last time that band was used on the rig. If you disable SPLIT
it should be fine the next time you change to that band. The same
applies for other bands. The change in behaviour is that WSJT-X, via
Hamlib, is changing bands on your rig as if you have clicked the target
band button before changing to the target frequency in that band. The
reason for the change is that other settings are also recalled per band
like the aerial socket, pre-amp settings, etc..
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
