Bill, sorry, but the update do not fix the problem., it makes it worse. Error 1) the same mistake as before with the switch to split. Error 2 VFO A LED flashed and no signal receive after band change.after pushing the VFO A knop at trx, the trx work well until next band change.Then the error occurs again Regards73 DirkDD5KD Am Mittwoch, 17. Februar 2021, 16:29:20 MEZ hat Bill Somerville <g4...@classdesign.com> Folgendes geschrieben: On 17/02/2021 15:03, Dirk Kuschke via wsjt-devel wrote: Hello, since FTDX version 2.3.0 my yaesu ftdx3000d changes to split mode when I change the frequency, using the button on the left. Up to version WSJTX2.2.2 this was not the case. The settings are: I change the Databits between 7 or 8 and the Stop bits between 1 or 2 with no effect. The correct setting Databit 8 and 2 Stop bits lt. Yaesu UK. In the settings i also change the radio to Yaesu FT-950 with the same affect change to split mode…. 73, Dirk Hi Dirk, if this is happening when you change bands then it is because SPLIT was set the last time that band was used on the rig. If you disable SPLIT it should be fine the next time you change to that band. The same applies for other bands. The change in behaviour is that WSJT-X, via Hamlib, is changing bands on your rig as if you have clicked the target band button before changing to the target frequency in that band. The reason for the change is that other settings are also recalled per band like the aerial socket, pre-amp settings, etc.. 73 Bill G4WJS. _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
