G4WJS - Found a local to test with on MSK144. The CQ 266 seems to work OK, but I still see the freq display on the K3s flicker when switching from transmit to receive.
W9MDB - Installed the version you sent me. I’m calling it rc3b. Split Operation > Fake It. FT8 50.313, call CQ tx dF 2100 Hz; radio goes up to .314 to transmit, down to 313.5 for receive. Each time up 1 kHz, back down 500 Hz. Transmit dF 700 Hz; radio moves down 1 kHz, back up only 500 Hz. Transmit dF 1800 Hz, no freq change, but the freq display still flickers when changing from TX to RX. This did not happen in v2.3.0 or earlier. Split Operation > Rig. Radio behaves properly but freq display still flickers when changing from TX to R|X. K1JT - Hi Joe! Still remember hoisting cold 807s with you in the hospitality suite at W9DXCC a few years back. That was cool! Once again: K3s with internal sound card. 1 USB cable for both audio and rig control Lenovo Thinkpad WIN10 Pro THANK YOU! Just decoded a CQ from Z8RRUFL09OW. That’s some SERIOUS DX! 73, Mike Cizek WØVTT > On Mar 18, 2021, at 5:43 PM, Bill Somerville <g4...@classdesign.com> wrote: > > >> On 18/03/2021 22:25, Joe Taylor wrote: >> Hi Mike, >> >> On 3/18/2021 5:55 PM, Mike Cizek W0VTT wrote: >> >>> Using Split Operating > Rig seems to work fine on FT8. I can’t find anyone >>> on meteors right now to test it split on MSK144. >> >> "Split" is not used (and not relevant) in MS144 mode. >> >> -- Joe, K1JT > Hi Mike, and Joe, > > I will qualify that with, split is used to call for replies on a different > working frequency, it is not used to optimize away audio harmonics since the > MSK144 signal fills a typical SSB passband. > > 73 > Bill > G4WJS. > > _______________________________________________ > wsjt-devel mailing list > wsjt-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
