Thank you sir. Will do. Gary K9RX
Sent from Mail for Windows From: Joe Taylor Sent: Wednesday, February 22, 2023 11:18 AM To: WSJT software development Cc: K9RX Subject: Re: [wsjt-devel] Possible issue with ECHO mode - 2.6.0 Hi Gary, On 2/22/2023 10:28 AM, K9RX via wsjt-devel wrote: > I like to use ECHO to test the station on 6M EME. > > But the latest version has changed enough I was wondering if there was a > short help file for it? Better than a short help file: there's a full paper about Echo mode. See item #34 here: https://wsjt.sourceforge.io/refs.html . > Also: The Echo graph will at times show the echo centered – and other > times show it offset. I have a jpg showing a recent echo run where the > echo was very strong – and it was showing it as the right numeric > doppler shift, 96 Hz, but it was showing it on the graph as -96Hz and > there was no SNR value reported (-99.0 shown). You can see the echo on > the wide graph – you can see the echo on the echo graph – but both have > it lower than it should be… > > A few minutes earlier I had 2 echos at -14.6 and others in to the low > 20’s – these were all showing on the spreadsheet – and “properly” on > both the wide and echo graphs. > > Gary Myers > K9RX Set up Echo mode as described in the paper referenced above. Be sure to check Doppler tracking on the Astronomical Data window, and select "Own Echo" for Doppler Tracking mode. Your echo should always be centered at frequency offset 0. SNR values are accurate and reliable. -- 73, Joe, K1JT
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
