Thank you – I’ll look this over to see if it addresses the echo appearing differently in both the wide and echo graph.
Gary Sent from Mail for Windows From: Charles Suckling via wsjt-devel Sent: Wednesday, February 22, 2023 10:53 AM To: WSJT software development Cc: Charles Suckling Subject: Re: [wsjt-devel] Possible issue with ECHO mode - 2.6.0 Hi Gary Have a look at these, which will hopefully help. https://wsjt.sourceforge.io/Echo_Mode_in_WSJT-X_2.6.0.pdf http://www.bobatkins.com/radio/EME_WSJTX_echo_mode_basic_guide.html 73 Charlie DL3WDG On Wed, 22 Feb 2023 at 16:37, K9RX via wsjt-devel <wsjt-devel@lists.sourceforge.net> wrote: I like to use ECHO to test the station on 6M EME. But the latest version has changed enough I was wondering if there was a short help file for it? Also: The Echo graph will at times show the echo centered – and other times show it offset. I have a jpg showing a recent echo run where the echo was very strong – and it was showing it as the right numeric doppler shift, 96 Hz, but it was showing it on the graph as -96Hz and there was no SNR value reported (-99.0 shown). You can see the echo on the wide graph – you can see the echo on the echo graph – but both have it lower than it should be… A few minutes earlier I had 2 echos at -14.6 and others in to the low 20’s – these were all showing on the spreadsheet – and “properly” on both the wide and echo graphs. Gary Myers K9RX Sent from Mail for Windows _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
