Try this in the TNC Port: /dev/cu.USA19H3d1P1.1
Cheers,
Nick
On 4/12/11 8:25 PM, Jeremy McDermond wrote:
On Apr 12, 2011, at 7:57 PM, Jarett DeAngelis wrote:
Hi gang,
I'm trying to figure out how to get my Kenwood TM-D710A working with Xastir on
my Snow Leopard-powered Mac.
I have a Prolific Technology serial-USB Kenwood cable that I know works at least to
program the radio with under Windows. I know the programming cable doubles as a TNC
connection cable. I am pretty sure that you put the TNC into "PACKET12" mode
to make it ready to transmit data via the port on the back of the head unit.
Then what? I tried configuring Xastir to use a "Serial KISS TNC" on
/dev/ttys0. When I start the device in Interface Control, Xastir freezes. Not really
sure where to proceed from here.
You have to use the correct serial port name. /dev/ttys0 is for Linux. My
Prolific based serial interface shows up as /dev/cu.PL2303-00004326. At a
command line prompt, do something like:
ls /dev/cu.*
And you'll show all the appropriate serial devices.
Thanks in advance, folks. I would RTFM if I had one ;)
--
Jeremy McDermond (NH6Z)
Xenotropic Systems
[email protected]
_______________________________________________
Xastir mailing list
[email protected]
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
_______________________________________________
Xastir mailing list
[email protected]
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
