Hello Romano,
After ./configure, the first shot at make failed: it seems that it was
searching for aclocal-1.11 and automake-1.11 explicitly, when I have
version 1.13. Ok, I symlinked 1.13 to 1.11 and it went on.
By the way, the solution to this is mentioned somewhere in the compile
instructions, and it is to run the commands "aclocal", "automake",
and "autoconf" before continuing with the usual "./configure", "make",
and "make install".
That's sort of irrelevant if you downloaded the latest tarball, though.
---Tim
+--------------------------------+-------------------------------------+
| R. Timothy Edwards (Tim) | email: t...@opencircuitdesign.com |
| Open Circuit Design | web: http://opencircuitdesign.com |
| 22815 Timber Creek Lane | phone: (301) 528-5030 |
| Clarksburg, MD 20871-4001 | cell: (240) 401-0616 |
+--------------------------------+-------------------------------------+
_______________________________________________
Xcircuit-dev mailing list
Xcircuit-dev@opencircuitdesign.com
http://www.opencircuitdesign.com/mailman/listinfo/xcircuit-dev
