Hello! I'm from Russia so please excuse my terrible english. Please help me with my problem! My OS is FreeBSD 4.6 and I have a problem with X-server - i couldn't run it i "good" mode. I have motherboard T810b-se with i810 chipset and onboard vigeo. My monitor is Samsung SyncMaster 755DFX it's horizontal sync raange 30-85 kHz, vertical 50-160 Hz. My xfree version is 4.2.0. I think that the trouble is with video card. I can run X-Server (KDE) with driver "vga" (standard VGA) In that case the "Device" section in my XF86Config file is
identifier "svga" driver "vga" With standard VGA driver I can run X-Server in 320x200 (8 bit) or 640x480 (4 bit). I'd like to run it in the mode 800x600 (8 or 16 bit). This mode is certainly supported by Intel 810 graphics controller. So please tell me ho can I do that. I tryed to use VESA and i810 drivers but when I startx my monitor's screen becomes black (monitor turns off). With both these two drivers i tryed to specify many other optons: for the videoRam parameter I tryed to use 4096 (so it shown in Windows 2000) and 1024 values (so it shown in /root/XF86Config.new in FreeBSD). I tryed to specify many other parameters such as Vendor, PCI Bus, BoardName, chipset with values that shown in XF86Config.new. I tryed to use XF86Config.new at the place of XF86Config. I tryed to specify single monitor's horizSync and VertRefresh such as: HorizSync 46.875 VertRefresh 75 (these parameters are written in monitor's documentation for 800x600 mode). So my question is what shall i specify in XF86Config in device Section. Many thanks, Petrov Pavel. _______________________________________________ XFree86 mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xfree86
