On Wednesday, March 20, 2002, at 09:23 AM, Randall Watt wrote:
> > >> -----Original Message----- >> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf >> Of Josh Hogan >> Sent: Tuesday, March 19, 2002 7:25 PM >> To: [EMAIL PROTECTED] >> Subject: [Xpert]Xinerama Problem with XFree86 4.1.0 >> >> >> Hello. I've recently been trying to get the Xinerama extensions with >> XFree86 4.1.0 (stock from Redhat 7.2 install, no updates) working. My >> computer is a P2 233, with two video cards: >> >> Onboard Matrox 1064SG, on the PCI bus >> Matrox 2064W PCI card in PCI slot >> >> If I use just the 1064SG onboard card, it works flawlessly. If I place >> the 2064W card in, it works flawlessly as well. So, I tried to setup >> the Xinerama extensions. It appears that I have the configuration file >> setup properly, but here is a copy of it (The 1064 card is labeled as >> Onboard, the 2064 is labeled as PCI) > > The 2064W (original Millennium) has a vga enable/disable switch right > on the > card. You may need to change the setting. > I did find the switch on the 2064W. It was set to "VGA Enable". I changed it over to "VGA Disable". When I did that, the machine booted up with the onboard card flawlessly -- the first time it's done it with the Millenium in a PCI slot :) However . . . I changed back over to my Xinerama-enabled config file and tried to start it up -- the machine then hard-locked (ssh died, no ping, etc.). So I rebooted the machine and tried to start XF86 with just the Millenium (specifying it via BusID) -- it hard-locked the machine again. I currently have the onboard 1064SG (btw, the chip itself on the MoBo reads it as a 1164SG) set in the BIOS to NOT auto-disable. Should the Millenium be set to disable or enable? Thanks again for the help :) Josh _______________________________________________ Xpert mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xpert
