> <[email protected]> wrote: >> Just so I'm clear. You are asking about the switch to 3.0 as the >> default ? If so, that was only done in master for the upcoming 1.2 >> release and not on the edison branch, so you wouldn't pick it up >> by pulling. > > Thanks! I did a git checkout -b master origin/master and will try again.
Thanks Bruce for pointing me in the right direction. I just wanted to follow up. I switched to master branch and did a clean build for Beagleboard. I can confirm that it worked. I blew my SD Card away and put freshly built yocto images of MLO, u-boot.bin & uImage and my Beagleboard xM boots fine (one last question after this output below): Texas Instruments X-Loader 1.5.0 (Jan 11 2012 - 12:41:55) Beagle xM Reading boot sector Loading u-boot.bin from mmc U-Boot 2011.06 (Jan 11 2012 - 12:41:50) OMAP3630/3730-GP ES1.0, CPU-OPP2, L3-165MHz, Max CPU Clock 1 Ghz OMAP3 Beagle board + LPDDR/NAND I2C: ready DRAM: 512 MiB NAND: 256 MiB MMC: OMAP SD/MMC: 0 In: serial Out: serial Err: serial Beagle xM Rev A No EEPROM on expansion board Die ID #335000001bf00000015739ea07035019 Hit any key to stop autoboot: 0 SD/MMC found on device 0 reading uEnv.txt ** Unable to read "uEnv.txt" from mmc 0:1 ** reading uImage 3106612 bytes read Booting from mmc ... ## Booting kernel from Legacy Image at 82000000 ... Image Name: Linux-3.0.12-yocto-standard+ Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 3106548 Bytes = 3 MiB Load Address: 80008000 Entry Point: 80008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK Starting kernel ... Uncompressing Linux... done, booting the kernel. Yocto (Built by Poky 6.0) 1.1+snapshot-20120111 beagleboard ttyO2 beagleboard login: root root@beagleboard:~# ls root@beagleboard:~# uptime 19:06:08 up 0 min, load average: 1.08, 0.30, 0.10 root@beagleboard:~# uname -a Linux beagleboard 3.0.12-yocto-standard+ #1 PREEMPT Wed Jan 11 13:53:06 EST 2012 armv7l GNU/Linux root@beagleboard:~# ... so now I'm back to trying to get poky to use my local linux-yocto-3.0 git repo. One more question. When I setup linux-yocto_3.0.bbappend in poky-extras/meta-kernel-dev/recipies-kernel/linux, do I use "yocto/standard/beagleboard" for KMACHINE? Thanks again, Brian _______________________________________________ yocto mailing list [email protected] https://lists.yoctoproject.org/listinfo/yocto
