I hope I've made the correct decision not to have the PAN editor automatically 
wrap lines.

On Mon, 13 Aug 2007 07:50:44 +0200, Uli Kunitz wrote:

> could you please provide the output of:
> cat /proc/version

/proc/version:

Linux version 2.6.23-rc2-070812-vanilla ([EMAIL PROTECTED]) (gcc version 4.1.3 
20070718 (prerelease) (Debian 4.1.2-14)) #1 Sun Aug 12 15:41:11 PDT 2007

> and could you send us the relevant output of /var/log/kern.log or dmesg.

dmesg:

[   41.522418] uhci_hcd 0000:00:07.2: UHCI Host Controller
[   41.525012] uhci_hcd 0000:00:07.2: new USB bus registered, assigned bus 
number 1
[   41.527358] uhci_hcd 0000:00:07.2: irq 11, io base 0x00004000
[   41.530533] usb usb1: configuration #1 chosen from 1 choice
[   41.533003] hub 1-0:1.0: USB hub found
[   41.535378] hub 1-0:1.0: 2 ports detected
[   41.879794] usb 1-1: new full speed USB device using uhci_hcd and address 2
[   42.052160] usb 1-1: configuration #1 chosen from 1 choice
[   43.012361] ieee80211_crypt: registered algorithm 'NULL'
[   43.029959] ieee80211: 802.11 data/management/control stack, git-1.1.13
[   43.032656] ieee80211: Copyright (C) 2004-2005 Intel Corporation <[EMAIL 
PROTECTED]>
[   43.211683] usb 1-1: reset full speed USB device using uhci_hcd and address 2
[   43.339402] zd1211rw 1-1:1.0: eth0
[   43.342473] usbcore: registered new interface driver zd1211rw
[   46.670149] zd1211rw 1-1:1.0: firmware version 4605
[   46.706631] zd1211rw 1-1:1.0: zd1211 chip 0ace:1211 v4330 full 00-11-a3 
AL2230_RF pa0 -----
[   46.985900] NET: Registered protocol family 17
[   54.594641] SoftMAC: Open Authentication completed with 00:20:a6:50:93:2b

(some extraneous messages removed)

Off-topic:  While the USB hub detects 2 ports, I only find one on this Thinkpad 
600X.

The completed SoftMAC authentication is after I've logged in and issued 
`iwconfig eth0 essid off`, as can be seen in the syslog.

kern.log looks the same as dmesg.  You can see the reported behavior in syslog:

Aug 13 12:15:08 celestial kernel: [   46.670149] zd1211rw 1-1:1.0: firmware 
version 4605
Aug 13 12:15:08 celestial kernel: [   46.706631] zd1211rw 1-1:1.0: zd1211 chip 
0ace:1211 v4330 full 00-11-a3 AL2230_RF pa0 -----
Aug 13 12:15:08 celestial kernel: [   46.985900] NET: Registered protocol 
family 17
Aug 13 12:15:10 celestial dhclient: DHCPDISCOVER on eth0 to 255.255.255.255 
port 67 interval 8
Aug 13 12:15:18 celestial dhclient: DHCPDISCOVER on eth0 to 255.255.255.255 
port 67 interval 10
Aug 13 12:15:28 celestial dhclient: DHCPDISCOVER on eth0 to 255.255.255.255 
port 67 interval 19
Aug 13 12:15:28 celestial kernel: [   54.594641] SoftMAC: Open Authentication 
completed with 00:20:a6:50:93:2b
Aug 13 12:15:47 celestial dhclient: DHCPDISCOVER on eth0 to 255.255.255.255 
port 67 interval 20
Aug 13 12:15:47 celestial dhclient: DHCPOFFER from 192.168.0.1
Aug 13 12:15:47 celestial dhclient: DHCPREQUEST on eth0 to 255.255.255.255 port 
67
Aug 13 12:15:47 celestial dhclient: DHCPACK from 192.168.0.1
Aug 13 12:15:48 celestial dhclient: bound to 192.168.0.65 -- renewal in 1626 
seconds.

(extraneous entries from avahi-daemon, cron, and others removed)

At 12:15:10 the debian dhclient begins polling.  Just before 12:15:28 is when 
I've successfully logged in and issued `iwconfig eth0 essid off`, at which 
point the SoftMAC authentication is completed.  dhclient is then able to 
successfully negotiate with the access point.

I'll begin building a full debug kernel with debug zd1211rw support today.  
This laptop is only 500 MHz.  I may have debugging output available in a few 
hours.


-------------------------------------------------------------------------
This SF.net email is sponsored by: Splunk Inc.
Still grepping through log files to find problems?  Stop.
Now Search log events and configuration files using AJAX and a browser.
Download your FREE copy of Splunk now >>  http://get.splunk.com/
_______________________________________________
Zd1211-devs mailing list - http://zd1211.wiki.sourceforge.net/
Unsubscribe: https://lists.sourceforge.net/lists/listinfo/zd1211-devs

Reply via email to