I have a linux router with 2 real interfaces (only one is active), 1 vmnet8 (vmware) interface to access VMs running in a DMZ subnet, plus 2 VPN interfaces for VPN connections.
When I model this device, the network listing shows the external IPs and their networks OK, plus the VPN interfaces and their networks OK. However, the vmnet8 interface does not have any network listed (ie: 10.2.3.1/24 should have network 10.2.3.0 )- but it's blank. Consequently, (i think), in the routing section where it lists nexthop - the ip 10.2.3.1 (none) is shown. As if zenoss isn't realizing that 10.2.3.1 is a valid IP for this device. I've tried adding routes so that my routing table says 10.2.3.0 has a gateway of 10.2.3.1 - to see if I could force it - but it doesn't seem to make a difference. So how is the Network column of the Interface section populated? and what entries do I need to get it populated? Thanks -------------------- m2f -------------------- Read this topic online here: http://community.zenoss.com/forums/viewtopic.php?p=15602#15602 -------------------- m2f -------------------- _______________________________________________ zenoss-users mailing list [email protected] http://lists.zenoss.org/mailman/listinfo/zenoss-users
