I tried that first. In my case it resulted in what I considered an
unacceptable deformation of the front panel. Maybe I just had a bad
stackup of tolerances. YMMV!
73,
Josh W6XU
On 12/28/2012 4:14 PM, Don Wilhelm wrote:
Rick,
Apply some pressure between the board and the front panel metalwork -
Squeeze with thumb and fingers while tightening the knurled nut with
the other hand. Tighten until the washer is tight. That method will
do no harm.
73,
Don W3FPR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html