Have you checked the obvious things? I feel qualified offering the
following suggestions as I've made all of these mistakes myself :-)
- Make sure the antenna is plugged into the right connector. If your
KAT2 is connected, use one of the "Antenna Tuner" connectors on the
back side of the top panel. If the KAT2 is NOT connected, use the
Antenna connector on the back of the bottom cover next to the power
connector.
- Make sure the KAT2 RF cable (J7) is connected to P6 on the RF
board. (I don't know if it's changed, but it used to be that the RF
connector (P6) and the battery connector (P3) were the same. There
are warnings in the manual about getting them mixed up.)
- Make sure the KAT2 control cable (J8) is plugged into P4 on the
Control Board correctly. The green wire should be at the top.
73
--
Joe KB8AP
On May 15, 2008, at 10:26 AM, MTcja wrote:
Just throwing this out there while I start backtracking to figure it
out.
I have installed the K160RX, KAT2, KBT2 and now the KSB2. Prior to
install
I was able to hear activity on the bands. After install I could
hear very
few stations.
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com