Nice! I'd love to see the tool change and tool length measure operation. And maybe clear out more of the chips while it's cutting. John
> -----Original Message----- > From: andrew beck [mailto:[email protected]] > Sent: September 10, 2025 2:28 AM > To: Enhanced Machine Controller (EMC) > Subject: [Emc-users] Quick video from today running production job on CNC. > Linuxcnc fun > > Hey guys I just took this little video today as one of my machines was > running. > > It's basically a haas vf3 but maybe a slightly heavier machine > > Making 200 of these parts. Takes 13min per part to make 1 finished part. > So about 50min cycle time. > > There is not many videos on the Internet showing linuxcnc getting used in > an actual production environment. > > So I try to show videos of how good it is. > > This job has about 10 different tools and lots of cool stuff to make it run > smoothly. And it also automatically measures the tools when needed. As I > am setting up for a job. > I have 4 air blast units under sprockets that blast the chips out when > cutting the inside square. > > I just did a quick job and wired the solenoids into a few spare outputs on > the 7i84 mesa card. > > > https://youtu.be/49G4X1Nfmu0?si=wFrkGbNTekLQODr6 > > > Should have 3 machines running at once tomorrow... fun times > > > Cheers andrew > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
