> each other, to the tune of .100 off at 10" from zero. I have checked my > machine squareness and I believe it is less than .010 on a 12" piece. All > > When I set up my gantry, I used a v bit and generated an array of "+" signs (just barely scratched in) across a clean sheet of MDF. I then carefully measured out all the resulting distances and found I had to adjust my scale ever so slighly to get it to cut exactly where required.
Brian ------------------------------------------------------------------------------ Virtualization & Cloud Management Using Capacity Planning Cloud computing makes use of virtualization - but cloud computing also focuses on allowing computing to be delivered as a service. http://www.accelacomm.com/jaw/sfnl/114/51521223/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users